Skip to content
Opið í Skútuvogi 6 á föstudaginn 27.des frá 10:00-16:00
Opið í Skútuvogi 6 föstudaginn 27.des frá 10-16
Slice engineering Temperature sensor Hitamælir RTD Pt1000

Hitamælir RTD Pt1000

by Slice engineering
6.450 kr - 6.450 kr
6.450 kr
6.450 kr - 6.450 kr
6.450 kr
Availability:
Low stock
SKU
×

We often restock popular items or they may be returned by the other customers. If you would like to be notified when this happens just enter your details below.

Hitamælir RTD Pt1000

Please select variant
Please enter name
Invalid email address
Required mobile number Invalid number Invalid country code Too short Too long ✓ Valid
Your notification has been registered. Close
Looks like you already have notifications active for this size!

We respect your privacy and don't share your email with anybody.

×

We have cancelled your request.

Hitamælir frá SliceEngineering RTD Pt1000, athugið þarfnast breytingar á firmware til að hitamælirinn virki.

Nánari upplýsingar frá framleiðanda:

Pt1000 Resistance Temperature Detector (RTD) uses a platinum resistor for the ultimate in temperature sensing performance. Works with Duet 3 and other high amperage boards out of the box. Perfect for any Pt1000-compatible 3D printers.  
  • Accurate from freeze-your-butt-off cold (-50 °C) to instantly-boil-your-innards hot (500 °C)
  • Totally linear temperature response improves sensing accuracy across the range
  • Virtually eliminates lead measurement error inherent in Pt100 sensors
  • Highly accurate, IEC 60751 Class B tolerance (+/- 0.3 +0.005 |t| °C)
  • 15 mm long. 3 mm diameter sensor cartridge 
  • 2 m long bare leads allow for easy adaptation to any 3D printer build
  • 300 series stainless steel cartridge to boost durability
  • Robust, thin-film construction sensor
  • 100% Made in USA

Note: A dowel pin is included to fill in the extra space in the temperature sensor slot on the hot block. More information can be found here.

NOTE: Installation of a new thermistor will require selecting the correct sensor in your firmware settings. Some printers may require an update of the RT table in the printer firmware, especially for the 450°C Thermistor. Not all 3D printers allow firmware updates. Please check to ensure your printer will allow firmware updates, otherwise the thermistor will not work.


×

We often restock popular items or they may be returned by the other customers. If you would like to be notified when this happens just enter your details below.

Please select variant
Please enter name
Invalid email address
Required mobile number Invalid number Invalid country code Too short Too long ✓ Valid
Your notification has been registered. Close
Looks like you already have notifications active for this size!

We respect your privacy and don't share your email with anybody.

×

Thank you, we have now received and recorded your request to be notified should Hitamælir RTD Pt1000 be restocked.

We will only use your email for this purpose.

We have cancelled your request.