Diamant dichtol AM Makro spray - 500ml.
For larger pores (0.1 – 0.5 mm)
• Contains organic solvents
• High temperature resistance (300°C)
• Surface dry after 6 minutes
The dichtol AM Makro Spray is a ready-to-use product with a special polymer formulation that reliably impregnates leaking components and seals large pores of size 0.1 to 0.5 mm. It exhibits high pressure resistance and provides temporary protection from corrosion or during transport.
Suitable for:
- capillary-active deep impregnation of micropores, hairline cracks and porosities,
- targeted serial impregnation,
- single-point impregnation of large components,
Preparation and application:
Before application, the pores to be sealed must be thoroughly cleaned of dirt residues and other undesirable substances.
Apply the dichtol AM Macro Spray four times at 1-minute intervals and keep it moist for at least 5 minutes to allow the product to penetrate the pores deeply. Note that the temperature of the object to be impregnated should not exceed 40°C. The penetration of the polymer cannot be guaranteed at higher temperatures.
The impregnating agent dries completely in a few hours, thus the treated components can be used after a short period of time.
Storage: Store the unopened product in a cool and dry place (+5°C to +20°C).
Shelf life: 5 years.
Hazard and precautionary statements
Signal word: Danger
Precautionary statements:
- P210 - Keep away from heat, hot surfaces, sparks, open flames and other ignition sources. No smoking.
- P211 - Do not spray on an open flame or other ignition source.
- P233 - Keep container tightly closed.
- P251 - Do not pierce or burn, even after use.
- P261 - Avoid breathing dust/fume/gas/mist/vapours/spray.
- P271 - Use only outdoors or in a well-ventilated area.
- P280 - Wear protective gloves/protective clothing/eye protection/face protection.
- P310 - Contact your doctor/poison control centre immediately.
- P312 - Call a POISON CENTRE/doctor if you feel unwell.
- P304+P340 - IF INHALED: Remove person to fresh air and keep comfortable for breathing.
- P305+P351+P338 - IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing.
- P308+P313 - IF exposed or concerned: Get medical advice/ attention.
- P501 - Dispose of contents/container at an industrial incineration plant.
Hazard statements:
- H223 - Flammable aerosol
- H229 - Pressurized container: may burst if heated
- H318 - Causes serious eye damage.
- H336 - May cause drowsiness or dizziness


