Polymaker PolyLite LW-PLA 800gr.
LW er LightWeight efni eða fis PLA frá Polymaker, hentugt þegar prentaðir eru aukahlutir fyrir flygildi svo sem dróna eða RC flugvélar
PolyLite™ LW-PLA is a special foamed PLA designed to print with similar settings as regular PLA but with half the weight. PolyLite™ LW-PLA is not an active foaming filament, which means it will not foam when extruded from the nozzle depending on the temperature. PolyLite™ LW-PLA is already pre-foamed.
PolyLite™ LW-PLA is designed for ease of print and strong rigidity. For more information check out the review below about PolyLite™ LW-PLA for RC Plane application.
Highlights:
Recommended Settings
- Printing Temperature: 190˚C - 210˚C
- Bed Temperature: 30˚C - 50˚C
- Printing Speed: 25mm/s - 60mm/s
- Fan: ON
Direct Drive:
- Retraction Distance: 3mm
- Retraction Speed: 40mm/s
Indirect Drive (Bowden setup):
- Retraction Distance: 6mm
- Retraction Speed: 60mm/s
You do not need to change any settings from your regular Polymaker PLA settings (slight increase retraction) as PolyLite™ LW-PLA will offer light weight results even when printing at very low temperature (~190˚C).
The lower the temperature the higher quality the print.
